[U-Boot-Users] U-Boot 1.1.3 does not boot with MPC8349E
Florian Behrens
flobe01 at arcor.de
Wed Oct 19 09:23:15 CEST 2005
I didn't change the flash address but rather the text segment start address from 0xFE700000 to 0xFE000000 in board/mpc8349ads/config.mk (see also my message from 2005-10-11 08:25).
I used the commands as described in the README:
tftp 10000 u-boot.bin
protect off fe000000 fe09ffff
erase fe000000 fe09ffff
cp.b 10000 fe000000 a0000
Servus,
Florian.
Matthew McClintock <msm at freescale.com> schrieb am 19.10.2005 09:00:50:
> Did you find a solution to your problem? Neil Chu just sent a patch in
> today that corrects values in the MPC8349 readme. Can you give a listing
> of the commands you used to program the new u-boot onto your board?
>
> -Matthew
>
>
> On Mon, 2005-10-10 at 18:15 +0200, flobe01 at arcor.de wrote:
> > Has anybody tried to bring up U-Boot 1.1.3 together with a (Power
> Quicc II Pro) MPC8349E MDS Processor Board (silicon rev 1.0)? The
> board comes with a (probably patched) 1.1.2 version installed. I
> want to update it to 1.1.3 in order to be able to use a current
> Linux kernel (2.6.13 - U-Boot 1.1.2 seems to be incompatible due to
> differences in the bd_info structures, right?).
> >
> > After building U-Boot and writing to the flash according to the
> README, the board does show no more signs of life (apart from the
> reset sequence leds) after hard reset.
> >
> > I used crosstool 0.38 for building the tool chain with a standard
> ppc target (-mcpu=powerpc) and gcc 3.4.1.
> >
> > Are there any board settings necessary other than those defaults
> in the Getting Started guide?
> >
> > Thanks and regards,
> > Florian.
Machen Sie aus 14 Cent spielend bis zu 100 Euro!
Die neue Gaming-Area von Arcor - über 50 Onlinespiele im Angebot.
http://www.arcor.de/rd/emf-gaming-1
More information about the U-Boot
mailing list