[U-Boot-Users] MAC address setting

[Jevgeni Zolotarjov]

Hi all!

I have custom designed ARM board, based on AT91RM9200EK reference design. 
Hardware works fine.
And I have following problem: When U-boot loads Kernel image from tftp, 
everything fine. When U-Boot starts kernel from flash, then Linux cannot 
communicate to ethernet device. I understand, that this is because MAC 
address was not set by U-Boot. But I could not find a command to initialise 
Ethernet.
Please advice, how to act.

Best regards,
Jevgeni