[U-Boot-Users] MPC8349E-MDS broken in git head, ok at U-Boot-1_1_4

[Ben Warren]

Dave,

I did a virgin git-clone this morning and got U-boot running on my
MPC8349EMDS.  I'm afraid there's nothing too exotic in the methods,
though.  Here's the sequence:

1.    host$ cg-clone git://www.denx.de/git/u-boot.git
2.    host$ make MPC8349EMDS_config
3.    host$ make all
4.    Cold boot board and BDI-2000
5.    Program image:
        8349>erase 0xfe000000 0x20000 2
        Erasing flash at 0xfe000000
        Erasing flash at 0xfe020000
        Erasing flash passed
        8349>prog 0xfe000000 mpc8349emds/u-boot.bin.0721 BIN
        Programming mpc8349emds/u-boot.bin.0721 , please wait ....
        Programming flash passed
        8349>reset run

I checked all switches and jumpers on the board to make sure I hadn't
changed anything.  No dice.

Here's the [TARGET] portion of my BDI-2000 config file.  This morning I
didn't override the HRCW, but have played around with that in the past
when things didn't do what I wanted:

[TARGET]
CPUTYPE     8349                   ;the CPU type
JTAGCLOCK   0                      ;use 16 MHz JTAG clock
POWERUP     2000             ;start delay after power-up detected in ms
WAKEUP      500                         ;give reset time to complete
STARTUP     RESET                  ;halt immediately at the boot vector
;STARTUP     RUN                   ;halt immediately at the boot vector
;RCW         0xb060a000 0x04040000     ; low boot memory, TSEC 1&2 GMII
;BOOTADDR    0xfff00100            ;boot address used for start-up break
BOOTADDR    0x00000100             ;boot address used for start-up break
BREAKMODE   SOFT      	;SOFT or HARD, HARD uses PPC hardware breakpoint
;STEPMODE    HWBP       ;TRACE or HWBP, HWBP uses a hardware breakpoint
STEPMODE    TRACE       ;TRACE or HWBP, HWBP uses a hardware breakpoint
MMU         XLAT 0xc0000000             ;enable address translation
PTBASE		0x000000f0
;SIO         8023 115200

I suspect your config file has the high boot address, and that's why
it's not working.  Dave Liu hinted towards that, I believe.

Let me know if there's any other information you need.

regards,
Ben