[U-Boot-Users] ML403 Uboot Linux Boot Error

[alayrac christophe]

I'm coming back to the comunitee with good news , especially for me !-)

I succeed to start linux (2-4.26) from u-boot 1.1.4 on ML403.

When U-boot start I press enter to stop autostart.

Then I type the following commands :

	=> setenv bootargs
	=> fatload ace 0 400000 linux/vmlinux.uboot
	=> bootm 400000

In fact the first command is the reason of hang up after 
	#Uncompressing Kernel Image .... Ok
My goal was to preserve command line set up in the Kernel configuration
(using NFS)

If I type only the last two commands, the Kernel start properly on the
root file system of the Compact Flash (due to u-boot default bootargs).

I did not succeed to run under emulator to try to figure out what's
going wrong.
I do not succeed to activate break points with the command (under gdb)
	monitor bps do_bootm hw

Is this U-boot behaviour normal?

A second question is :
What is the starting point to have I2C EEPROM available on that ML403
board under U-boot to save environnement and us autostart?

Kinds regards

Chris