[U-Boot-Users] mail not added in mailing list, what's wrong?

Arun Bothe group.arun at gmail.com
Sat Aug 18 14:58:35 CEST 2007


Hi Wolfgang,

I am Arun, new in U-Boot, I have some queries regarding U-Boot, and to get
the answers I sent a mail on Aug. 17, 2007, but that mail is not listed in
mailing list.
But when I am searching for that mail using particular string, I found that.

Can I know why this happen, and not included in list?

So, Again I am resending same mail.

---------- Forwarded message ----------
From: Arun Bothe <group.arun at gmail.com>
Date: Aug 17, 2007 5:26 PM
Subject: Hi, I am new to U-Boot, how do I get started?
To: u-boot-users at lists.sourceforge.net

Hi,

I am new to U-Boot. Currently I am working for adm5120 board.
I read "readme" file, and "DULG.pdf",  & U-Boot mailing archive also.

ADM5120 / ADM5120P
Specs:

    * 175MHz/227MIPS 4Kc CPU with an embedded cache, 8K-byte I-cache and 8K
D-cache MIPS32
    * 5 IEEE 802.e Fast Ethernet PHY interfaces and 1 GMII/MII interface
    * Two SDRAM banks (each bank 1M-32 up to 32Mx32Bit)(support upto
2Mx32Bytes)
    * Two Flash banks up to 4MB(NOR Flash and Nand Flash), and many more.


I have few questions regarding this, are

My "config.mk" file contains
    #ROM version
    TEXT_BASE = 0x80100000
    PRE_TEXT_BASE = 0xBFC00000

Q1: TEXT_BASE is the location of U-Boot in RAM, means TEXT_BASE points to
SDRAM perticular location? or tell more about TEXT_BASE.
Q2: In my board setting CFG_MONITOR_BASE=TEXT_BASE, means my boot monitor
code reading from EEPROM?
*****************************
For my board setting
#define CFG_SDRAM_BASE             0x80000000     and
#define CFG_MEMTEST_START      0x80100000
#define CFG_MEMTEST_END          0x81000000

Q3: CFG_MEMTEST_START, and CFG_MEMTEST_END are simple memory test area, but
I don't understand purpose of this test or which test and purpose?
*****************************
In my board setting
/* addresses for switch descriptors and buffers
 * reason for those fixed address is that the adm5120 switch
 * engine can only deploy descriptors and packet buffers
 * @ address < 16MB.
 * 0x80000000 ~ 0x80100000 is now reserved, so it SHOULD be safe
 * to put the addresses within this area
 */
#define CFG_PKTBUF_ADDR         0x800C0000
#define CFG_ARPBUF_ADDR         0x800D0000
#define CFG_DESC_ADDR           0x800F0000
Q4: means?


Q5: Which are the other important configuration macro's I've to study? or
I've to pay more attention?

Q6: Where I get more help of U-Boot for ADM5120, excepts the above mentioned
files?

Thanks
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.denx.de/pipermail/u-boot/attachments/20070818/87709e5a/attachment.htm 


More information about the U-Boot mailing list