[U-Boot-Users] Configuring MAC address for DAVICOM-9161
Santi Gopal Mondal
santigopal_mondal at mindtree.com
Wed Dec 5 07:37:55 CET 2007
Hi all,
I am using an at91rm9200ek type board which has got a davicom9161 chip
for ethernet. I am not able to write the MAC address or read it from any
register ( Specifically from u-boot).
Even though the environment variables are set accordingly.
setenv ethaddr 00:11:22:33:44:55
saveenv
While booting from the flash the kernel shows the message
at91_ether: Your bootloader did not configure a MAC address.
While booting from a NFS server the kernel does not show this kind of
message.
Thanks in advance.
SantiGopal Mondal
Senior Engineer,RDS
Mindtree Consulting
DISCLAIMER:
This message (including attachment if any) is confidential and may be privileged. If you have received this message by mistake please notify the sender by return e-mail and delete this message from your system. Any unauthorized use or dissemination of this message in whole or in part is strictly prohibited.
E-mail may contain viruses. Before opening attachments please check them for viruses and defects. While MindTree Consulting Limited (MindTree) has put in place checks to minimize the risks, MindTree will not be responsible for any viruses or defects or any forwarded attachments emanating either from within MindTree or outside.
Please note that e-mails are susceptible to change and MindTree shall not be liable for any improper, untimely or incomplete transmission.
MindTree reserves the right to monitor and review the content of all messages sent to or from MindTree e-mail address. Messages sent to or from this e-mail address may be stored on the MindTree e-mail system or else where.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.denx.de/pipermail/u-boot/attachments/20071205/26752886/attachment.htm
More information about the U-Boot
mailing list