[U-Boot-Users] ERROR during booting linux from board

[Vishal M]

Hi,


I'm Vishal. Working on the project 'arm linux porting to at91rm9200dk'.I
have cross-compiled the linux kernel 2.6.11 for arm architecture and
then converted zimage to uImage using mkimage tool.
The uImage I've downloaded successfully through serial  port. While
booting using bootm command from prompt on hyper terminal ,I got the
error as follows:

AT91RM9200-DK> loadb 0x20000000
## Ready for binary (kermit) download ...
## Start Addr      = 0x20000000
AT91RM9200-DK> bootm 0x20000000
## Booting image at 20000000 ...
   Image Name:   Linux-2.6.11-patch
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    851208 Bytes = 831 kB = 0 MB
   Load Address: 20008000
   Entry Point:  20008000
   Verifying Checksum ... OK
   Loading Kernel Image ... 851208 bytes from 0x20000040 to 0x20008000OK
Can't boot image type 2
AT91RM9200-DK>


What may be the causes for this problem.Need the help in this regard.


Thanks and Regards

-- 
Vishal M <vishal.m at globaledgesoft.com>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.denx.de/pipermail/u-boot/attachments/20070130/7681fb8a/attachment.htm 
-------------- next part --------------
This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended solely for the use of the addressee(s). If you are not the intended recipient, please notify the sender by e-mail and delete the original message.Global Edge Software Ltd has taken every reasonable precaution to minimize this risk, but is not liable for any damage you may sustain as a result of any virus in this e-mail. You should carry out your own virus checks before opening the e-mail or attachment. Global Edge Software Ltd reserves the right to monitor and review the content of all messages sent to or from this e-mail address