[U-Boot-Users] Latest git not working for MPC8349EMDS
Benedict, Michael
MBenedict at twacs.com
Wed May 2 20:49:27 CEST 2007
Timur Tabi wrote:
> Benedict, Michael wrote:
>> Any ideas why the switch is not working?
>
> I don't think they work on the ITX either. Some of them
> depend on I2C, which doesn't make
> sense because I2C isn't initialized at power-on.
Okay, this all makes more sense now. If I switch SW4:8 FCFG to '1',
then the config is read from the flash (so it must not depend on I2C).
The BMS was a red herring. This means that the final RCW settings
should be:
=> md.b e2400000 20
e2400000: 2f 0c 40 08 86 af 07 33 ff ff 47 12 ff ff ff 02
/. at ....3..G.....
e2400010: 22 07 05 19 24 ff ff ff ff ff ff ff ff ff ff ff
"...$...........
(note at e2400000 now because I am running on new u-boot source).
I was off-by-one... e240000 is BSCSR10 not BCSR11, so other people
should have the same value for this register.
Thanks again to everyone!
Michael
More information about the U-Boot
mailing list