[U-Boot-Users] Booting with attached BDI but not alone

[Ben Warren]

DI BACCO ANTONIO - technolabs wrote:
> Hi,
>  
> I downloaded an u-boot.bin (1.1.4) on to my flash (a board with 
> MPC875). If I connect BDI and type go I see output on my serial 
> console. If I start the board without the attached BDI nothing appears.
>  
> Any hint?
> ------------------------------------------------------------------------
>
> -------------------------------------------------------------------------
> This SF.net email is sponsored by: Microsoft
> Defy all challenges. Microsoft(R) Visual Studio 2005.
> http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
> ------------------------------------------------------------------------
>
> _______________________________________________
> U-Boot-Users mailing list
> U-Boot-Users at lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/u-boot-users
>   
Maybe your BDI config file initializes something that U-boot doesn't.  
If you take everything out of the [INIT] section, do you get the same 
behavior?

regards,
Ben