[U-Boot-Users] Booting with attached BDI but not alone (only ICTRL remained in BDI cfg)

[DI BACCO ANTONIO - technolabs]

> just a stupid idea:
>did you connect a pull-up resistor to BKPT on your board?

My Board is an evaluation board and it worked till few months ago. 

Now I removed any initialization from cgf file of BDI. Only special
register 158 is set to 0x00000007 and I cannot remove this, otherwise
BDI complains about halting the target.

Anyway the board continues to boot only using BDI not alone.

Now I don't understand what could be the problem. Should I set SPR 158
from within u-boot to 0x00000007?

Bye,
Antonio.