[U-Boot-Users] R: Booting with attached BDI butnot alone (onlyICTRL remained in BDI cfg)

[DI BACCO ANTONIO - technolabs]

>Have you used a voltage meter or oscilloscope to check the voltage
>level? Have you measured the resistance between SRESET and GND and
>between SRESET and supply? Have you checked if your processor pin
>is connected? Probably either the pull-up resistor isn't mounted or
>your PCB is defective.

Thank you for your suggestions but my board is an evaluation board named
adder875. It worked and after connecting a wiggler with the connector
upside down exibihts this strange behaviour. Anyway I 
will measure the voltage of the pins you suggested.

Bye,
Antonio.