[U-Boot-Users] DDR2 (Moduel 512M) work unstablely when enable the ECC

[jxnuxdy]

Hi,     I bring up the u-boot in my 440EPx based on board successfully, it work fine when I disable the ECC, however when I enable the ECC I found it work unstablely in u-boot, for example it sometimes crashed in 'tftp' download.     Is there someone also encounter this issue? My code AS below:long int sequoia_sdram_init (int board_type)
{
#if !defined(CONFIG_NAND_U_BOOT) || defined(CONFIG_NAND_SPL)
 u32 val = 0;
 ulong speed = get_bus_freq(0); mtsdram(DDR0_02, 0x00000000); mtsdram(DDR0_00, 0x0000190A);
 mtsdram(DDR0_01, 0x01000000);
 mtsdram(DDR0_03, 0x02030602); //CASLAT = 3, CLATLN = 3
 //mtsdram(DDR0_03, 0x02040802); //CASLAT = 4, CLATLN = 4 //mtsdram(DDR0_04, 0x0A020200);
 mtsdram(DDR0_04, 0x0C020200); mtsdram(DDR0_05, 0x02020308);
 mtsdram(DDR0_06, 0x0102C812);
 mtsdram(DDR0_07, 0x000D0100);
 // mtsdram(DDR0_08, 0x02430001); //WR = 2 (far CAS 3)
 mtsdram(DDR0_08, 0x02C80001); //when in doubt set tcpd to 200cycles 08/28/07
 //mtsdram(DDR0_08, 0x03430001); //WR = 2 (far CAS 4) //mtsdram(DDR0_09, 0x00011D5F); // 75ohm RTT //mtsdram(DDR0_09, 0x00001D5F); // Termination disabled /* for tuning WDS */
 //mtsdram(DDR0_09, 0x00011D50);
 //mtsdram(DDR0_09, 0x00011D4F);
 mtsdram(DDR0_09, 0x00011D40); //mtsdram(DDR0_10, 0x00000300); // dual rank mtsdram(DDR0_10, 0x00000100); // single rank mtsdram(DDR0_11, 0x0027C800);
 mtsdram(DDR0_12, 0x00000003);
 //mtsdram(DDR0_14, 0x00000000);
 mtsdram(DDR0_14, 0x00000100);
 mtsdram(DDR0_17, 0x19000000);
 mtsdram(DDR0_18, 0x19191919);
 mtsdram(DDR0_19, 0x19191919);
 mtsdram(DDR0_20, 0x0B0B0B0B);
 mtsdram(DDR0_21, 0x0B0B0B0B);
 //mtsdram(DDR0_22, 0x00267F0B); // no ECC
 //mtsdram(DDR0_22, 0x03267F0B); // enable ECC /* for tuning DQSOSH */
 //mtsdram(DDR0_22, 0x0026700B); // no ECC
 //mtsdram(DDR0_22, 0x03266F0B); // ECC
 mtsdram(DDR0_22, 0x0026600B); // ECC mtsdram(DDR0_23, 0x00000000);
 //mtsdram(DDR0_24, 0x01010002); //ODT_WR_MAP_CS0 =
 mtsdram(DDR0_24, 0x01010001); //ODT_WR_MAP_CS0 = printf("DDR Init: speed = %d \n", speed);
 if (speed > 133333334) {
  mtsdram(DDR0_26, 0x5B26050C);
 }
 else {
  mtsdram(DDR0_26, 0x5B260408);
 } mtsdram(DDR0_27, 0x0000682B);
 mtsdram(DDR0_28, 0x00000000);
 mtsdram(DDR0_31, 0x00000000);
 //mtsdram(DDR0_42, 0x01000006);
 mtsdram(DDR0_42, 0x00000006);
 mtsdram(DDR0_43, 0x030A0200);
 mtsdram(DDR0_44, 0x00000003);
 mtsdram(DDR0_02, 0x00000001); wait_for_dlllock();
#endif /* #ifndef CONFIG_NAND_U_BOOT */#ifdef CONFIG_DDR_DATA_EYE
 /* -----------------------------------------------------------+
  * Perform data eye search if requested.
  * ----------------------------------------------------------*/
 denali_core_search_data_eye(CFG_MBYTES_SDRAM << 20);
#endif#ifdef CONFIG_DDR_ECC{
 unsigned long write_addr;
 unsigned long registerVal;
 unsigned long memory_size = (CFG_MBYTES_SDRAM << 20); /* 0- Enable ECC */
 mtdcr(ddrcfga, DDR0_22);
 registerVal = mfdcr(ddrcfgd);
 registerVal = (registerVal &~ DDR0_22_CTRL_RAW_MASK) | DDR0_22_CTRL_RAW_ECC_ENABLE;
 mtdcr(ddrcfgd, registerVal); /* 1- Clear entire memory content */
 write_addr = CFG_SDRAM_BASE;
 printf("ECC Enabling\n");
 printf("Start memory clearing @ 0x%08x size = 0x%08x...", write_addr, memory_size);
 while (write_addr < memory_size) {
  *((unsigned long*)write_addr) = write_addr;
  write_addr += 8;
#ifdef DDR_DEBUG_SIZE
  if ( (write_addr % 0x10000000 ) == 0)
   printf("addr = 0x%08x \n", write_addr );
#endif
 }
 printf("   DONE\n"); /* 2- Clear error status */
 mtdcr(ddrcfga, DDR0_00);
 registerVal = mfdcr(ddrcfgd);
 mtdcr(ddrcfgd, (registerVal | DDR0_00_INT_ACK_ALL)); /* 3- Set 'int_mask' parameter to functionnal value */
 #ifdef DDR_DEBUG
 printf("Set 'int_mask' parameter to functionnal value\n");
 #endif
 mtdcr(ddrcfga, DDR0_01);
 registerVal = mfdcr(ddrcfgd); mtdcr(ddrcfgd, ((registerVal &~ DDR0_01_INT_MASK_MASK)
  | DDR0_01_INT_MASK_ALL_OFF));
}
#endif mtdcr(ddrcfga, DDR0_02);
 val = mfdcr(ddrcfgd); //dump_ddr2_regs(); return (CFG_MBYTES_SDRAM << 20);
}  - Denny 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.denx.de/pipermail/u-boot/attachments/20070926/6488c092/attachment.htm