[U-Boot-Users] AT91SAM9260EK with KS8721 PHY

[michael]

Hi,
> Sander Vermin a écrit :> I did a new build with:> > macb_eth_initialize(0, (void *)AT91_BASE_EMAC, 1<<5);> > in stead of:> > macb_eth_initialize(0, (void *)AT91_BASE_EMAC, 0x00);> > But still no PHY detected :-(> You need to check your schematic, and the PHY datasheet in order to know what could be the address of your PHY (set by pull up/down resistors on several pins of the PHY at reset of the PHY).
> Or you can try a loop on the PHY address and see if it answers at any address ...
>   
Try this code to do the loop test.

#if defined(CONFIG_YOURBOARD)
#define MAX_PHY_ADDR    64
        for (i = 0 ; i < MAX_PHY_ADDR; i++) {
                macb->phy_addr = i;
                phy_id = macb_mdio_read(macb, MII_PHYSID1);
                if (phy_id != 0xffff)
                        break;
        }
        printf("phy_id %x found at %d\n", phy_id, i);
#else
        phy_id = macb_mdio_read(macb, MII_PHYSID1);
#endif

Michael