[U-Boot] NAND: bad block in whole chip

[Stefan Roese]

On Wednesday 13 August 2008, Alemao wrote:
> Now i got all NAND stuffs from u-boot-1.3.4, including common/cmd_nand.c
> and drivers/mtd/nand/*, but still the same problem.
>
> Other components of u-boot can influence NAND behavior?
>
> I saw some people with similar problem using "nand scrub", but im little
> bit afraid with this command...

Yes, you should be. Be careful with this command.

Note that in all cases where I read all NAND blocks as bad, either the NAND 
driver had a problem or the hardware had a problem. Are you sure that the 
hardware is ok?

Best regards,
Stefan

=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================