[U-Boot-Users] [PATCH 3/7] sbc8560: define eth0 and eth1 instead of eth1 and eth2
Wolfgang Denk
wd at denx.de
Fri Jul 11 22:24:20 CEST 2008
In message <8dee444198e3c87ef471198cbd2e25c4e1b558fb.1215803423.git.paul.gortmaker at windriver.com> you wrote:
>
> +/* You can compile in a MAC address and your custom net settings by using
> + * the * following syntax. Your board should be marked with the assigned
----------^
Bogus '*' here?
> + * MAC addresses directly on it.
> + */
> +#if 0
> +#define CONFIG_ETHADDR 00:01:af:07:9b:8a
> +#define CONFIG_ETH1ADDR 00:01:af:07:9b:8b
> #define CONFIG_SERVERIP 192.168.0.131
> #define CONFIG_IPADDR 192.168.0.105
> -#define CONFIG_GATEWAYIP 0.0.0.0
> +#define CONFIG_GATEWAYIP 192.168.0.1
> #define CONFIG_NETMASK 255.255.255.0
> +#endif
> +
I think this should be removed. There is really no good reason to add
network configuration at all to the board config file (with the
exception of the 2 or 3 boards which actually boot from real ROM).
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
If in any problem you find yourself doing an immense amount of work,
the answer can be obtained by simple inspection.
More information about the U-Boot
mailing list