[U-Boot] [PATCH-OMAP3] OMAP3: Use I2C file coding style

[dirk.behme at googlemail.com]

Subject: [PATCH-OMAP3] OMAP3: Use I2C file coding style

From: Dirk Behme <dirk.behme at gmail.com>

Use file coding style for inx/outx instead of global coding style.

Signed-off-by: Dirk Behme <dirk.behme at gmail.com>

---

Note: There was an additional review comment about this file:

-- cut --
> +#define inb(a) __raw_readb(a)
> +#define outb(a, v) __raw_writeb(a, v)
>  #define inw(a) __raw_readw(a)
>  #define outw(a,v) __raw_writew(a,v)

This 4 macro is supposed to be defined in io.h
-- cut --

In ARM's io.h there are already inx/outx macros, but with different syntax. The correct fix for omap24xx_i2c.c will be to replace all inx/outx by readx/writex macros and remove above defines. But this can't be done on OMAP3 branch, as it would conflict with "no general coding style clean up in OMAP3 patches, only OMAP3 related changes, please". Thus, we have to do code style changes for this file at mainline once OMAP3 is merged. Until then we have to stay with consistent local style.

 drivers/i2c/omap24xx_i2c.c |   10 +++++-----
 1 files changed, 5 insertions(+), 5 deletions(-)

Index: u-boot-arm/drivers/i2c/omap24xx_i2c.c
===================================================================
--- u-boot-arm.orig/drivers/i2c/omap24xx_i2c.c
+++ u-boot-arm/drivers/i2c/omap24xx_i2c.c
@@ -115,7 +115,7 @@ static int i2c_read_byte (u8 devaddr, u8
 		status = wait_for_pin ();
 		if (status & I2C_STAT_RRDY) {
 #if defined(CONFIG_OMAP243X) || defined(CONFIG_OMAP34XX)
-			*value = inb(I2C_DATA);
+			*value = inb (I2C_DATA);
 #else
 			*value = inw (I2C_DATA);
 #endif
@@ -161,13 +161,13 @@ static int i2c_write_byte (u8 devaddr, u
 	if (status & I2C_STAT_XRDY) {
 #if defined(CONFIG_OMAP243X) || defined(CONFIG_OMAP34XX)
 		/* send out 1 byte */
-		outb(regoffset, I2C_DATA);
-		outw(I2C_STAT_XRDY, I2C_STAT);
+		outb (regoffset, I2C_DATA);
+		outw (I2C_STAT_XRDY, I2C_STAT);
 		status = wait_for_pin();
 		if ((status & I2C_STAT_XRDY)) {
 			/* send out next 1 byte */
-			outb(value, I2C_DATA);
-			outw(I2C_STAT_XRDY, I2C_STAT);
+			outb (value, I2C_DATA);
+			outw (I2C_STAT_XRDY, I2C_STAT);
 		} else {
 			i2c_error = 1;
 		}