[U-Boot] Problems booting without BDI

[Alemao]

Hi all,

I made a port of u-boot for my board, with MPC8343.

The problem is that when i run u-boot with the BDI2000 (using "reset run"
command), u-boot loads normally, but when i take off the BDI nothing
appears on serial.

BDI is setting the reset configuration word, and is the same word found
in u-boot image. I commented the line wich BDI sets the reset word, and
tried to read it from the BDI, its seems ok _BUT_, nothing appears on serial.

Any ideas about what could be happening?

Here is the reset configuration word that BDI and U-Boot are using:

BDI:
====

RCW   0xA0602000 0x04030000


U-Boot:
=======

00000000 - 04 04 04 04  04 04 04 04  03 03 03 03  03 03 03 03  ................
00000010 - 00 00 00 00  00 00 00 00  00 00 00 00  00 00 00 00  ................
00000020 - a0 a0 a0 a0  a0 a0 a0 a0  60 60 60 60  60 60 60 60  ................
00000030 - 20 20 20 20  20 20 20 20  00 00 00 00  00 00 00 00  ................
00000040 - 27 05 19 56  42 6f 6f 74    6c 6f 61 64    65 72 20 34
'..VBootloader 4
00000050 - 20 28 53 65  70 20 31 35  20 32 30 30  38 20 2d 20   (Nov 20 2008 -
00000060 - 31 37 3a 32  39 3a 33 38  29 20 4d 50  43 38 33 58  10:29:38) MPC83X
00000070 - 58 00 00 00  00 00 00 00  00 00 00 00  00 00 00 00  X...............


Thanks in advance,


--
Alemao