[U-Boot] Cannot enable interrupts Olimex SAM9-L9260

[Björn Saläng]

Thank you for your help! This task might be to hard for us, so we will try
to manage without interrupts.

Regards
Björn & Andreas

2008/10/1 Wolfgang Denk <wd at denx.de>

> Dear "=?ISO-8859-1?Q?Bj=F6rn_Sal=E4ng?=",
>
> In message <aa37bd180810010632r113b3d48lda818664b1e84357 at mail.gmail.com>
> you wrote:
> >
> > Hi again! Thank You Wolfgang for spending time on us.
>
> YOu are welcome - but please keep the list on Cc: !
>
> > So you are proposing we should rebuild U-boot and upload it on our board?
> To
>
> No - that will probably not be sufficient. You have to add the code
> first that implements interrupt support, it seems.
>
> > much about it. We hoped we only needed to change the binary file of our
> > standalone program compiled on our host computer.
> > Change U-boot or standalone binary?
>
> Extend the U-Boot code to add interrupt  support,  then  rebuild  and
> install the new U-Boot.
>
> Best regards,
>
> Wolfgang Denk
>
> --
> DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
> HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
> Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
> "There are three principal ways to lose money: wine, women, and engi-
> neers. While the first two are more pleasant, the third is by far the
> more certain."                           - Baron Rothschild, ca. 1800
>