[U-Boot] [PATCH v2] pci/fsl_pci_init: Enable inbound PCI config cycles

[Peter Tyser]

Set CFG_READY bit in Configuration Ready register for PCIe
interfaces and clear ACL bit in PBFR register for PCI
interfaces to allow devices to respond to incoming PCI
configuration cycles.

Signed-off-by: Peter Tyser <ptyser at xes-inc.com>
---
Changes since v1:
- Anal retentive update to the commit message:)

 drivers/pci/fsl_pci_init.c |   17 +++++++++++++++++
 1 files changed, 17 insertions(+), 0 deletions(-)

diff --git a/drivers/pci/fsl_pci_init.c b/drivers/pci/fsl_pci_init.c
index 7625ccc..6da9c22 100644
--- a/drivers/pci/fsl_pci_init.c
+++ b/drivers/pci/fsl_pci_init.c
@@ -37,6 +37,11 @@ DECLARE_GLOBAL_DATA_PTR;
 #include <pci.h>
 #include <asm/immap_fsl_pci.h>
 
+/* Freescale-specific PCI config registers */
+#define FSL_PCI_PBFR		0x44
+#define FSL_PCIE_CAP_ID		0x4c
+#define FSL_PCIE_CFG_RDY	0x4b0
+
 void pciauto_prescan_setup_bridge(struct pci_controller *hose,
 				pci_dev_t dev, int sub_bus);
 void pciauto_postscan_setup_bridge(struct pci_controller *hose,
@@ -302,6 +307,18 @@ void fsl_pci_init(struct pci_controller *hose)
 	if (temp16) {
 		pci_hose_write_config_word(hose, dev, PCI_SEC_STATUS, 0xffff);
 	}
+
+	/* Enable inbound PCI config cycles */
+	pci_hose_read_config_byte(hose, dev, FSL_PCIE_CAP_ID, &temp8);
+	if (temp8 != 0x0) {
+		/* PCIe - set CFG_READY bit of Configuration Ready Register */
+		pci_hose_write_config_byte(hose, dev, FSL_PCIE_CFG_RDY, 0x1);
+	} else {
+		/* PCI - clear ACL bit of PBFR */
+		pci_hose_read_config_word(hose, dev, FSL_PCI_PBFR, &temp16);
+		temp16 &= ~0x20;
+		pci_hose_write_config_byte(hose, dev, FSL_PCI_PBFR, temp16);
+	}
 }
 
 #ifdef CONFIG_OF_BOARD_SETUP
-- 
1.6.0.2.GIT