[U-Boot] Can't connect to PHY, BCM5461

[Simon Boman]

I added this code to the uec.c file:
	int i;
	for(i=0;i<20;i++)
	   printf("PHY value %d is %x\n", i, phy_read(uec->mii_info, i));

and got this to the prompt..

PHY value 0 is 0
PHY value 1 is 0
PHY value 2 is 0
PHY value 3 is 0
PHY value 4 is 0
PHY value 5 is 0
PHY value 6 is 0
PHY value 7 is 0
PHY value 8 is 0
PHY value 9 is 0
PHY value 10 is 0
PHY value 11 is 0
PHY value 12 is 0
PHY value 13 is 0
PHY value 14 is 0
PHY value 15 is 0
PHY value 16 is 0
PHY value 17 is 0
PHY value 18 is 0
PHY value 19 is 0

2008/10/29 Jerry Van Baren <gerald.vanbaren at ge.com>:
> Simon Boman wrote:
>>
>> Hi!
>>
>> I have a modified MPC8360 platform with a PHY named BCM5461 and UEC as
>> Ethernet Controller. I started with the MPC8360EMDS card from U-boot
>> and then modified it so that it match the card (what I know). I am
>> using the git-version of U-boot from October, 20, 2008.
>> The problem is that I can't even get contact with the PHY. It says
>> it's a generic phy, but even with that I can't get any contact to it
>> and the phy_ID u-boot prints is just 0.
>>
>> "UEC: PHY is Generic MII (0)"
>> "warning: FSL UEC0: timeout on PHY link"
>>
>> Hereafter the u-boot just hanging..
>>
>> TIA
>> Simon
>
> What does the MII command tell you about your MII bus in general and your
> PHY's registers?
>
> gvb
>