[U-Boot] [PATCH] CFI Driver: fix "flash not ready" problem

[Wolfgang Denk]

From: Wolfgang Denk <wd at xpert.denx.de>

This patch fixes a problem on systems where the NOR flash is attached
to a 64 bit bus.  The toggle bit detection in flash_toggle() is based
on the assumption that the same flash address is read twice without
any other interjacent flash accesses.  However, on 32 bit systems the
function flash_read64() [as currently implemented] does not perform
an atomic 64 bit read - instead, this is broken down into two 32 bit
read accesses on addresses "addr" and "addr + 4".  So instead of
reading a 64 bit value twice from "addr", we see a sequence of 4 32
bit reads from "addr", "addr + 4", "addr", and "addr + 4".  The
consequence is that flash_toggle() fails to work.

This patch implements a simple, but somewhat ugly solution, as it
avoids the use of flash_read64() in this critical place (by breaking
it down manually into 32 bit read operations) instead of rewriting
flash_read64() such to perform atomic 64 bit reads as one could
expect.  However, such a rewrite would require the use of floating
point load operations, which becomes pretty complex:

	save MSR;
	set Floating Point Enable bit in MSR;
	use "lfd" instruction to perform atomic 64 bit read;
	use "stfd" to store value to temporary variable on stack;
	load u64 value from temporary variable;
	restore saved MSR;
	return u64 value;

The benefit-cost ratio of such an implementation was considered too
bad to actually attempt this, especially as we can expect that such
an implementation would not only have a bigger memory footprint but
also cause a performance degradation.

Signed-off-by: Wolfgang Denk <wd at denx.de>
---
 drivers/mtd/cfi_flash.c |    3 ++-
 1 files changed, 2 insertions(+), 1 deletions(-)

diff --git a/drivers/mtd/cfi_flash.c b/drivers/mtd/cfi_flash.c
index c40bf66..24e9b9f 100644
--- a/drivers/mtd/cfi_flash.c
+++ b/drivers/mtd/cfi_flash.c
@@ -596,7 +596,8 @@ static int flash_toggle (flash_info_t * info, flash_sect_t sect,
 		retval = flash_read32(addr) != flash_read32(addr);
 		break;
 	case FLASH_CFI_64BIT:
-		retval = flash_read64(addr) != flash_read64(addr);
+		retval = ( (flash_read32( addr ) != flash_read32( addr )) ||
+			   (flash_read32(addr+4) != flash_read32(addr+4)) );
 		break;
 	default:
 		retval = 0;
-- 
1.5.4.rc1.23.g3a969