[U-Boot] Burning U-boot on 460EX using BDI3000

Felix Radensky felix at embedded-sol.com
Tue Sep 2 10:26:07 CEST 2008


Hi, Victor

Victor Gallardo wrote:
>  
> Hi Felix,
>
> Here is my BDI configuration file for Canyonlands.
>
> This one should work for you. This one configures OCM instead DDR.
>
> -Victor Gallardo
>
>   
Your configuration works fine, thanks a lot.

Felix.

> -----Original Message-----
> From: u-boot-bounces at lists.denx.de [mailto:u-boot-bounces at lists.denx.de]
> On Behalf Of Felix Radensky
> Sent: Monday, September 01, 2008 9:43 AM
> To: U-Boot
> Subject: [U-Boot] Burning U-boot on 460EX using BDI3000
>
> Hi,
>
> Can U-boot be burned on 460EX based board (using BDI3000) without
> configuring DDR controller ? The BDI configuration file for Canyonlands
> board on Denx site
> http://www.denx.de/wiki/view/DULG/Appendix#Section_13.1.
> has no DDR setup, but also doesn't work on Canyonlands (fails on flash
> erase). The configuration file from AMCC site does work, but it contains
> full DDR setup.
>
> Thanks a lot.
>
> Felix.
> _______________________________________________
> U-Boot mailing list
> U-Boot at lists.denx.de
> http://lists.denx.de/mailman/listinfo/u-boot
>   



More information about the U-Boot mailing list