[U-Boot] u-boot for BMW board

[Ramji PanchaReddy]

Hi Wolfgang,
Thanks a lot for your response ..

I also tried BMW_config and used cross-compiler as ppc_82xx-* .When i load
this i did not get any thing on console.
My processor is MPC8245.


Regards,
Ramji


On Wed, Sep 3, 2008 at 8:29 PM, Wolfgang Denk <wd at denx.de> wrote:

> Dear Ramji PanchaReddy,
>
> in message <96ce52d50809030639w747d050fhe918a0f3edd2c1c0 at mail.gmail.com>
> you wrote:
> >
> > I am using BMW board.
> > i used Sandpoint8245_config for board configuration based on the CPU
> > when i load the u-boot.bin i got following o/p
> ...
> > FLASH: *** failed ***
> > ### ERROR ### Please RESET the board ###
>
> Well, what did you expect when you configure for board "A" and run on
> board "B"?
>
> > 1.Did i configured u-boot correctly for my board.If so what else i have
> to
> > do  to boot the board smoothly.
>
> If you really have a "BMW" Board then you must configure U-Boot for
> the "BMW" board. Any other board configuration cannot work.
>
> > 2.which cross compiler i have to use to compile this and where can we get
> > it?
>
> You can for example use the ELDK. See
> http://www.denx.de/wiki/view/DULG/ELDKAvailability
>
> Best regards,
>
> Wolfgang Denk
>
> --
> DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
> HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
> Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
> This restaurant was advertising breakfast  any  time.  So  I  ordered
> french toast in the renaissance.            - Steven Wright, comedian
>