[U-Boot] BMP display.

[Tuma]

On Monday 17 August 2009 19:37:53 you wrote:
> > -----Original Message-----
> > From: u-boot-bounces at lists.denx.de
> > [mailto:u-boot-bounces at lists.denx.de] On Behalf Of Tuma
> > Sent: Monday, August 17, 2009 7:26 PM
> > To: Wolfgang Denk; U-Boot Mailing List
> > Subject: Re: [U-Boot] BMP display.
> >
> > On Monday 17 August 2009 16:38:31 you wrote:
> > > Dear Tuma,
> > >
> > > again: please keep the mailing list on Cc: !!!
> > >
> > > In message <200908171631.17975.chernigovskiy at spb.gs.ru> you wrote:
> > > > Okay. Is new version configurable for OMAP3evm out of the box?
> > >
> > > Yes.
> > >
> > > > And is the v2009.08-rc2 stable enought?
> > >
> > > Yes.
> >
> > Thank you. I've downloaded new U-Boot 2009.08.rc2.
> > I have some error while making it.
> > I do:
> > make distclean  (Okay)
> > make omap3_evm_config  (Okay)
> > make
> >
> > And get:
> >
> > make[1]: arm-linux-gcc: Command not found
> >
> > My old U-Boot used "arm-none-linux-gnueabi-gcc" which make
> > system could easyly
> > find on my system.
> > Should I install some new software to build new U-Boot?
> > Or configure existing Makefile?
>
> Can you try:
> make CROSS_COMPILE=arm-none-linux-gnueabi-


Oo, thank you! I forgot about CROSS_COMPILE=. In my old U-Boot this parameter 
was set in Makefile. In 2009 CROSS_COMPILE= in Makefile was ignored.

U-boot 2009 is built now, and runs on OMAP3 evm.

So I have to put i2c driver files (as .h as .c) to drivers/i2c and LCD driver 
file s (as .h as .c) to drivers/video?


> > > Best regards,
> > >
> > > Wolfgang Denk
> >
> > --
> > Software Developer
> > General Satellite Corp.
> > _______________________________________________
> > U-Boot mailing list
> > U-Boot at lists.denx.de
> > http://lists.denx.de/mailman/listinfo/u-boot



-- 
Software Developer
General Satellite Corp.