[U-Boot] Board is not booting after flashing U-boot and hard reset

[Stefan Roese]

Hi Prakash,

On Wednesday 30 December 2009 12:31:52 prakash bedge wrote:
> I am using PPC440GX.
> I did not understood what mean by EEPROM configuration. Do you want to say
> that board is using data from EEPROM?

I'm talking about the bootstrap controller of the PPC. I suggest you take a 
look at chapter "9. IIC Bootstrap Controller" for more information about this.

> I believe I am using fix configuration as I am not calling any I2C call in
> bootloader code.

You don't need to call it. The PPC is reading these I2C bootstrap values 
*before* starting the first lines of code from flash (if configured to use the 
I2C bootstrapping).

So how are the strapping pins (UART0_DCD, UART0_DSR) configured in your custom 
board?
 
Cheers,
Stefan

--
DENX Software Engineering GmbH,      MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich,  Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-0 Fax: (+49)-8142-66989-80 Email: office at denx.de