[U-Boot] [PATCH 2/4 v3] powerpc: 83xx: add support for the kmeter1 board

[Kim Phillips]

On Sat, 24 Jan 2009 00:36:34 +0100
Wolfgang Denk <wd at denx.de> wrote:

> Dear Heiko Schocher,
> 
> In message <4925268B.2020907 at denx.de> you wrote:
> > This patch adds support for the kmeter1 board from Keymile,
> > based on a Freescale MPC8360 CPU.
> > 
> > - serial console on UART 1
> > - 256 MB DDR2 RAM
> > - 64 MB NOR Flash
> > - Ethernet RMII Mode over UCC4
> > - PHY SMSC LAN8700
> > 
> > Signed-off-by: Heiko Schocher <hs at denx.de>
> > ---
> > 
> > changes since v2:
> > 
> >   added comments from Kim Philips
> >   added doc/README.kmeter1
> > 
> >  MAINTAINERS                     |    1 +
> >  MAKEALL                         |    1 +
> >  Makefile                        |    3 +
> >  board/keymile/kmeter1/Makefile  |   51 ++++
> >  board/keymile/kmeter1/config.mk |   24 ++
> >  board/keymile/kmeter1/kmeter1.c |  153 ++++++++++++
> >  doc/README.kmeter1              |   91 +++++++
> >  include/configs/kmeter1.h       |  523 +++++++++++++++++++++++++++++++++++++++
> >  8 files changed, 847 insertions(+), 0 deletions(-)
> >  create mode 100644 board/keymile/kmeter1/Makefile
> >  create mode 100644 board/keymile/kmeter1/config.mk
> >  create mode 100644 board/keymile/kmeter1/kmeter1.c
> >  create mode 100644 doc/README.kmeter1
> >  create mode 100644 include/configs/kmeter1.h
> 
> Applied, thanks.

eh?  this is sitting in u-boot-mpc83xx.git next - I was going to ask
you to pull soon.

Kim