[U-Boot] [PATCH 6/7] arm: add support for CONFIG_GENERIC_MMC

[Jean-Christophe PLAGNIOL-VILLARD]

On 10:56 Thu 28 May     , Andy Fleming wrote:
>    On Fri, May 22, 2009 at 7:27 PM, Jean-Christophe PLAGNIOL-VILLARD
>    <plagnioj at jcrosoft.com> wrote:
> 
>      On 03:56 Wed 20 May     , Ilya Yanok wrote:
>      > Signed-off-by: Ilya Yanok <yanok at emcraft.com>
>      > ---
>      >  lib_arm/board.c |    7 +++++++
>      >  1 files changed, 7 insertions(+), 0 deletions(-)
>      >
>      > diff --git a/lib_arm/board.c b/lib_arm/board.c
>      > index 5d05d9b..268532f 100644
>      > --- a/lib_arm/board.c
>      > +++ b/lib_arm/board.c
>      > @@ -48,6 +48,7 @@
>      >  #include <serial.h>
>      >  #include <nand.h>
>      >  #include <onenand_uboot.h>
>      > +#include <mmc.h>
>      >
>      >  #ifdef CONFIG_DRIVER_SMC91111
>      >  #include "../drivers/net/smc91111.h"
>      > @@ -439,6 +440,12 @@ extern void davinci_eth_set_mac_addr (const
>      u_int8_t *addr);
>      >  #ifdef BOARD_LATE_INIT
>      >       board_late_init ();
>      >  #endif
>      > +
>      > +#ifdef CONFIG_GENERIC_MMC
>      > +     puts ("MMC:   ");
>      > +     mmc_initialize (gd->bd);
>      > +#endif
>      do you use a embedded mmc?
>      otherwise I'll prefer to not init the mmc at the board init but on need
> 
>    This is the same way ethernet is initialized.  mmc_initialize should not
>    perform any SD/MMC transactions, but should set up the driver, and
>    register with the MMC subsystem.  Without doing this, there's no way to
>    address the MMC device from the command line...
ok

Best Regards,
J.