[U-Boot] Ethernet not working on OMAP3 board with
jcrigby at gmail.com
Sun Jun 7 04:12:38 CEST 2009
Does anyone know what the current status of this is? I see the patched
discussed in April was in net-next for a while then was removed with the
understanding that it would go into master since it was a bug fix but I
don't see it in master.
Also Mani says that the patch does not fix master anyway but does fix
Did I get that right?
On Thu, May 28, 2009 at 3:43 AM, Pillai, Manikandan <mani.pillai at ti.com>wrote:
> > -----Original Message-----
> > From: Pillai, Manikandan
> > Sent: Wednesday, May 27, 2009 10:01 AM
> > To: 'Josh Karabin'
> > Cc: Dirk Behme; u-boot at lists.denx.de
> > Subject: RE: [U-Boot] Ethernet not working on OMAP3 board with
> > OK I will try with the same commit and send the results.
> > > -----Original Message-----
> > > From: Josh Karabin [mailto:gkarabin at vocollect.com]
> > > Sent: Tuesday, May 26, 2009 8:26 PM
> > > To: Pillai, Manikandan
> > > Cc: Dirk Behme; u-boot at lists.denx.de
> > > Subject: Re: [U-Boot] Ethernet not working on OMAP3 board with
> > >
> > >
> > > Pillai, Manikandan wrote:
> > > > Hi Dirk,
> > > >
> > > > I have already tried this patch it does not work on EVM.
> > > > Was any other patch applied along with this ?
> > >
> > > That was the only one that I needed, on top of the arm/next branch from
> > > last week. The last commit was
> > > : "OMAP3: Fix CKE1 MUX setting to allow self-refresh".
> > >
> [Pillai, Manikandan] I tried with this commit and it works. If I use the
> v2009.06-rc1 tag with these changes it does not work.
> smc911x: initializing
> smc911x: detected LAN9115 controller
> smc911x: phy initialized
> Addrr = 0 1 2 2 4 4
> smc911x: MAC 00:01:02:02:04:04
> BOOTP broadcast 1
> BOOTP broadcast 2
> BOOTP broadcast 3
> BOOTP broadcast 4
> So guess there are some more changes that require to be done. Any ideas
> > > - Josh
> U-Boot mailing list
> U-Boot at lists.denx.de
More information about the U-Boot