[U-Boot] [PATCH 4/4] ZOOM1 Add power reset button
Tom
Tom.Rix at windriver.com
Fri Jun 12 23:57:06 CEST 2009
Jean-Christophe PLAGNIOL-VILLARD wrote:
> On 07:53 Wed 10 Jun , Tom Rix wrote:
>
>> The reset button is the red circle on the top right, front of
>> the board. Press and hold the button for 8 seconds to completely
>> reset the board.
>>
>> Signed-off-by: Tom Rix <Tom.Rix at windriver.com>
>> ---
>> board/omap3/zoom1/zoom1.c | 8 ++++++++
>> drivers/i2c/twl4030_i2c.c | 2 +-
>> include/configs/omap3_zoom1.h | 1 +
>> 3 files changed, 10 insertions(+), 1 deletions(-)
>>
>> diff --git a/board/omap3/zoom1/zoom1.c b/board/omap3/zoom1/zoom1.c
>> index db4d087..8a3afaf 100644
>> --- a/board/omap3/zoom1/zoom1.c
>> +++ b/board/omap3/zoom1/zoom1.c
>> @@ -31,6 +31,7 @@
>> * MA 02111-1307 USA
>> */
>> #include <common.h>
>> +#include <twl4030.h>
>> #include <asm/io.h>
>> #include <asm/arch/mux.h>
>> #include <asm/arch/sys_proto.h>
>> @@ -51,6 +52,13 @@ int board_init(void)
>> /* boot param addr */
>> gd->bd->bi_boot_params = (OMAP34XX_SDRC_CS0 + 0x100);
>>
>> + /*
>> + * Board Reset
>> + * The board is reset by holding the red button on the
>> + * top right front face for eight seconds.
>> + */
>> + twl4030_power_reset_init();
>> +
>> return 0;
>> }
>>
>> diff --git a/drivers/i2c/twl4030_i2c.c b/drivers/i2c/twl4030_i2c.c
>> index 549f974..00146f8 100644
>> --- a/drivers/i2c/twl4030_i2c.c
>> +++ b/drivers/i2c/twl4030_i2c.c
>> @@ -40,7 +40,7 @@ static inline int twl4030_i2c_read_u8(u8 chip_no, u8 *val, u8 reg)
>> */
>> void twl4030_power_reset_init(void)
>> {
>> -#ifdef CONFIG_OMAP3_ZOOM2
>> +#if defined(CONFIG_OMAP3_ZOOM2) || defined(CONFIG_OMAP3_ZOOM1)
>>
> I think it will be better to avoid board specifc code in the driver
> unless it's the only solution
>
>
I think this is zoom1 and zoom2 specific.
I could add this function to each of their board files.
I was trying to avoid that.
Tom
> Best Regards,
> J.
>
More information about the U-Boot
mailing list