[U-Boot] [PATCH 10/10] imx27lite: add support for imx27lite board from LogicPD

[Paul Thomas]

On Thu, Jun 11, 2009 at 3:38 PM, Paul Thomas <pthomas8589 at gmail.com> wrote:

>
> Note that the old version of that code is available in the "imx27lite"
>> branch of the u-boot-testing repository; see
>>
>> http://git.denx.de/?p=u-boot/u-boot-testing.git;a=shortlog;h=refs/heads/imx27lite
>
>
> Is this still the best branch for imx27lite? I'm not getting anything on
> the serial port when I run this? I'm using a crosstool NG cross-compiler
> "arm-unknown-linux-gnu-gcc (crosstool-NG-svn_trunk at 1300) 4.3.2". Will that
> work OK? It builds fine. If I load the redboot image then I do get output on
> the serial port, and both images seem to be located at 0xa7f00000 which
> should be fine.
>
> thanks,
> Paul
>

I did pull this tarball:
http://git.denx.de/?p=u-boot/u-boot-testing.git;a=shortlog;h=refs/heads/imx27lite-v2

But it's still not working. So to figure this out I started single stepping
through u-boot with gdb. I get to line 186 in lowlevel_init.S. The line is
"str r1, [r0, #ESDCFG1_ROF]". This looks like a simple simple store
instruction. Any thoughts as to why it stops there?

thanks,
Paul