[U-Boot] [PATCH v4 2/6] MX31: Add NAND SPL for i.MX31.
Jean-Christophe PLAGNIOL-VILLARD
plagnioj at jcrosoft.com
Sat Jun 20 14:47:52 CEST 2009
On 20:50 Sat 13 Jun , Magnus Lilja wrote:
> This patch adds the NAND SPL framework needed to boot i.MX31 boards
> from NAND.
>
> It has been tested on a i.MX31 PDK board with large page NAND. Small
> page NANDs should work as well, but this has not been tested.
>
> Note: The i.MX31 NFC uses a non-standard layout for large page NANDs,
> whether this is compatible with a particular setup depends on how
> the NAND device is programmed by the flash programmer (e.g. JTAG
> debugger).
>
> The patch is based on the work by Maxim Artamonov.
>
> Signed-off-by: Maxim Artamonov <scn1874 at yandex.ru>
> Signed-off-by: Magnus Lilja <lilja.magnus at gmail.com>
> ---
Applied to u-boot-arm
Best Regards,
J.
More information about the U-Boot
mailing list