[U-Boot] MPC8360ERDK U-Boot - Broadcom Gigabit Ethernet removal

[cmfairfa at rockwellcollins.com]

Hi,
I'm trying to completely remove the 2 gigabit ethernets from my U-Boot (as 
they are depopulated on my target). I want to use the other 2 ethernet 
ports as FSL UEC0 and FSL UEC1.
I've removed the UCC1 and UCC2 entries from the qe_iop_conf_tab in 
mpc8360erdk.c and updated the corresponding macros in MPC8360ERDK.h. The 
transmits seem to work. I'm able to communicate from the target to a TFTP 
server on a PC. However, the RX to the target is not working.
I get "FSL UEC: Rx error" messages.


Any ideas/suggestions as to what I need to do to get the RX to work?

Also, do I need to define CFG_CMD_MII  and/or CFG_MII, so that 
miiphy_register() is called in uec.c


Here are my new macro definitions in MPC8360ERDK.h:

#define CONFIG_UEC_ETH1 /* GETH1 */

#ifdef CONFIG_UEC_ETH1
#define CONFIG_SYS_UEC1_UCC_NUM  6      /* UCC7 */
#define CONFIG_SYS_UEC1_RX_CLK          QE_CLK19
#define CONFIG_SYS_UEC1_TX_CLK          QE_CLK20
#define CONIFG_SYS_UEC1_ETH_TYPE        FAST_ETH
#define CONFIG_SYS_UEC1_PHY_ADDR        1
#define CONFIG_SYS_UEC1_INTERFACE_MODE ENET_100_MII
#endif

#define CONFIG_UEC_ETH2 /* GETH2 */

#ifdef CONFIG_UEC_ETH2
#define CONFIG_SYS_UEC2_UCC_NUM  3      /* UCC4 */
#define CONFIG_SYS_UEC2_RX_CLK          QE_CLK7
#define CONFIG_SYS_UEC2_TX_CLK          QE_CLK8
#define CONIFG_SYS_UEC2_ETH_TYPE        FAST_ETH
#define CONFIG_SYS_UEC2_PHY_ADDR        3
#define CONFIG_SYS_UEC2_INTERFACE_MODE ENET_100_MII
#endif


Thanks


Christopher M. Fairfax
Sr. Software Engineer
Rockwell Collins
+1 540-428-3344
+1 540-428-3301
cmfairfa at rockwellcollins.com
This message contains PRIVILEGED AND PROPRIETARY INFORMATION intended 
solely for the use of the addressee(s) named above.  Any disclosure, 
distribution, copying or use of the information by others is strictly 
prohibited.  If you have received this message in error, please advise the 
sender by immediate reply and delete the original message.  Thank you.