[U-Boot] [PATCH] OMAP3 pandora: update pin mux for rev3 boards

[Jean-Christophe PLAGNIOL-VILLARD]

On 11:43 Fri 26 Jun     , Grazvydas Ignotas wrote:
> On Fri, Jun 26, 2009 at 12:59 AM, Jean-Christophe
> PLAGNIOL-VILLARD<plagnioj at jcrosoft.com> wrote:
> > On 14:57 Mon 08 Jun     , Grazvydas Ignotas wrote:
> >> The update consists of following changes:
> >> - remove configuration of not connected pins, effectively
> >>   leaving them in safe mode.
> >> - remove unused GPIOs, setup newly added ones.
> >> - setup pulls for various GPIOs. Disable pulls for game
> >>   buttons, as they have external pulls.
> >> - SDRC CS change based on recent patch for
> >>   Beagle and Overo.
> >>
> >> Old boards are no longer supported, but there was only
> >> small number of test boards made. Updated configuration
> >> is expected to be used for mass production.
> > If user have old version in possession NACK
> 
> There are only several old prototypes some developers have, there is
> really no need to complicate code to support those boards. The old
> boards will be replaced anyway as they don't fit into the case.
If only one active user have the board we need to support it
> 
> > this kind of huge update is non bisectable
> 
> Yes but current boards don't even work with what is in mainline, so it
> doesn't make much sense to bisect anyway.
> 
> > so we do need to use a true mux api
> > as the kernel lot's of other arch in u-boot
> 
> You could be right, but I don't think I can contribute this at the
> moment. Current mux api is good enough for single configuration we
> need.
no it's a mess to use and manage and duplicate code

Best Regards,
J.