[U-Boot] [patch arm/next] dm355 evm support (v3)

Jean-Christophe PLAGNIOL-VILLARD plagnioj at jcrosoft.com
Wed May 13 01:20:20 CEST 2009


On 19:58 Mon 11 May     , David Brownell wrote:
> From: David Brownell <dbrownell at users.sourceforge.net>
> 
> Initial U-Boot support for the DaVinci DM355 EVM.  This is a board
> from Spectrum Digital.  Board docs include schematic and firmware
> for its microcontroller:
> 
>   http://c6000.spectrumdigital.com/evmdm355/revd/
> 
> Most of the DM355 chip is fully documented by TI, the most notable
> exception being the MPEG/JPEG coprocessor (programmable using codecs
> available at no cost from TI), which is omitted from its DM335 sibling:
> 
>   http://focus.ti.com/docs/prod/folders/print/tms320dm355.html
> 
> This version can boot from the on-board DM9000 Ethernet chip, after
> being loaded (from NAND, MMC/SD, or UART).  In the near future, NAND
> and USB support could be added ... NAND support is being held back
> until the support for the 4-bit ECC hardware is ready.
> 
> Signed-off-by: David Brownell <dbrownell at users.sourceforge.net>
> ---
Applied to arm/next

Best Regards,
J.


More information about the U-Boot mailing list