[U-Boot] [PATCH] mmc: it's safe to ignore mmc_send_if_cond() return value

alfred steele alfred.jaquez at gmail.com
Thu May 14 22:24:53 CEST 2009


Thanks for the much waited reply.

> I've only tried my patch on i.MX27 board. I mentioned that it may work
> on MX3's too cause the kernel driver used as a source works on both MX2
> and MX3. You need to do some changes for my driver to work on MX3. Check
> the pins configuration and if you have MCI clock signal enabled.
As a quickstart, I am actually trying to look at the  mxcmci_probe()
for the init stuff. I hope thats the correct approach for finding the
initialization stuff.
Another
For the GPIOs  to set the signals right(data/clk/cmd) , i am using the
following chunk of code.


Also
> you should use another function to get the clock rate on MX31. Sorry, I
> can't debug the driver on mx31 now, you should do it yourself.
Apologize if i had menat  that in my emails, i never meant that  you
test it on the mx31 board

>Probably
 you may also want to discard my generic mmc patches (except for this
> one) and pull from u-boot-mmc tree instead.
Would it matter even if i use the patch?


More information about the U-Boot mailing list