[U-Boot] [PATCH 1/2] ZOOM2 Add serial support.

Jean-Christophe PLAGNIOL-VILLARD plagnioj at jcrosoft.com
Sun May 17 11:38:34 CEST 2009


On 13:49 Sat 16 May     , Tom Rix wrote:
> Zoom2 serial is in general supplied by one of the 4 UARTS on the debug board.
> The default serial is from the USB connector on left side of the debug board.
> The USB connector will produce 2 of the 4 UARTS.  On your host pick the first
> enumeration.
> 
> The details of the setting of the serial gpmc setup are not available.
> The values were provided by another party.
> 
> The serial port set up is the same with Zoom1.
> Baud rate 115200, 8 bit data, no parity, 1 stop bit, no flow.
> 
> The kernel bootargs are
> console=ttyS3,115200n8
> 
> Signed-off-by: Tom Rix <Tom.Rix at windriver.com>
> 
> ixx
> Signed-off-by: Tom Rix <Tom.Rix at windriver.com>
???
> ---
Applied to arm/next

Best Regards,
J.


More information about the U-Boot mailing list