[U-Boot] [PATCH V5 0/4] add TI DA8xx support:

[Tom]

Nick Thompson wrote:
> Add initial support for DA8xx SoC's and the spectrum digital DA830 EVM board.
> 
> See:
> 	http://www.ti.com
> 	http://www.spectrumdigital.com/
> 
> DA8xx is similar to DaVinci devices, but has a differing memory map and
> updated peripherals. It is intended that DaVinci drivers will be modified in
> some way to support these differences.
> 
> A side effect of this is that there are some legacy code constructs in this
> patch set that are required to utilize the DaVinci drivers as they stand now.
> For example there are some volatiles and memory pointer types defined that are
> no longer considered acceptable.
> 
> The new code in this patch set doesn't use these constructs and the remaining
> artefacts can be removed when the DaVinci drivers stop using them.
> 
> This patch set is based on code originally from TI.
> ---
> Changes from previous patch set:
> 
> #defines of constant variables to lower case
> load registers only as required in clk_get()
> 


> This patch set depends on "[PATCH V3] Davinci: add a pin multiplexer
>     configuration API" posted on 2009-11-04

Yes it is dependent.
There is a compile error without the pin mux function.

Once the pin multiplex patch is ack-ed then
Ack to this patch set.

Thanks
Tom


> 
> Applies to u-boot-ti:
> _______________________________________________
> U-Boot mailing list
> U-Boot at lists.denx.de
> http://lists.denx.de/mailman/listinfo/u-boot