[U-Boot] USB device support for OMAP3

[Dirk Behme]

Tom wrote:
> The recently posted patches enable usb device support for omap3
> They are against the repository  http://git.denx.de/u-boot-arm.git, 
> branch 'next'
> 
> You can also view them in my development tree
> http://dev.omapzoom.org/?p=trix/u-boot.git;a=shortlog;h=refs/heads/arm-next-development 
> 
> starting at commit 50031bc80615f4fcafcdc613020b87a326aaed92
> 
> The device support was usbtty.
> This was run tested on beagle, zoom1 and zoom2.
> The maintainer of the beagle and zoom1 boards should decide if they want 
> a usb device
> starting for their board.

Great work!

Yes, I think we want this :)

Best regards

Dirk

> For zoom2, the usbtty is the console when the debug board is not present.
> 
> There were some small changes to the musb common code.
> The devinci maintainer should check that their host support is ok.
> 
> There is a large change to usb structures that should be also tested out.
> I ran this through MAKEALL arm, mips and ppc but I do not have a board 
> that uses
> usb in host mode. 
> After this I plan on submitting a new usb device called 'fastboot'
> It provides a limited set of basic commands to help develop over just usb.
> Here is a link.
> https://gforge.ti.com/gf/project/omapzoom/wiki/?pagename=FAQ-8%3A+Zoom-II+Android%C2%A0fastboot 
> 
> 
> Tom