[U-Boot] [PATCH 2/2 v2] tools/netconsole: use ncb automatically if available

[Mike Frysinger]

The standard netcat, while ubiquitous, doesn't handle broadcast udp packets
properly.  The local ncb util does however.  So if ncb can be located in
the standard locations, automatically use that instead.

Signed-off-by: Mike Frysinger <vapier at gentoo.org>
---
v2
	- split the changes
	- search PATH rather than CWD
	- update docs

 doc/README.NetConsole |   24 +++---------------------
 tools/netconsole      |   17 ++++++++++++++---
 2 files changed, 17 insertions(+), 24 deletions(-)

diff --git a/doc/README.NetConsole b/doc/README.NetConsole
index 639cc12..c8bcb90 100644
--- a/doc/README.NetConsole
+++ b/doc/README.NetConsole
@@ -36,27 +36,9 @@ you can just remove the -p option from the script.
 It turns out that 'netcat' cannot be used to listen to broadcast
 packets. We developed our own tool 'ncb' (see tools directory) that
 listens to broadcast packets on a given port and dumps them to the
-standard output. use it as follows:
-
-+++++++++++++++++++++++++++++++++++++++++++
-#! /bin/bash
-
-[ $# = 1 ] || { echo "Usage: $0 target_ip" >&2 ; exit 1 ; }
-TARGET_IP=$1
-
-stty icanon echo intr ^T
-./ncb &
-nc -u ${TARGET_IP} 6666
-stty icanon echo intr ^C
-kill 0
-+++++++++++++++++++++++++++++++++++++++++++
-
-Again, this script takes exactly one argument, which is interpreted
-as the target IP address (or host name, assuming DNS is working). The
-script can be interrupted by pressing ^T (CTRL-T).
-
-The 'ncb' tool can be found in the tools directory; it will be built
-when compiling for a board which has CONFIG_NETCONSOLE defined.
+standard output.  It will be built when compiling for a board which
+has CONFIG_NETCONSOLE defined.  If the netconsole script can find it
+in PATH or in the same directory, it will be used instead.
 
 For Linux, the network-based console needs special configuration.
 Minimally, the host IP address needs to be specified. This can be
diff --git a/tools/netconsole b/tools/netconsole
index 6ef2723..c8109bb 100755
--- a/tools/netconsole
+++ b/tools/netconsole
@@ -39,9 +39,20 @@ echo "NOTE: the interrupt signal (normally ^C) has been remapped to ^T"
 
 stty -icanon -echo intr ^T
 (
-while ${nc} -u -l -p ${port} < /dev/null ; do
-	:
-done
+if type ncb 2>/dev/null ; then
+	# see if ncb is in $PATH
+	exec ncb ${port}
+
+elif [ -x ${0%/*}/ncb ] ; then
+	# maybe it's in the same dir as the netconsole script
+	exec ${0%/*}/ncb ${port}
+
+else
+	# blah, just use regular netcat
+	while ${nc} -u -l -p ${port} < /dev/null ; do
+		:
+	done
+fi
 ) &
 pid=$!
 ${nc} -u ${ip} ${port}
-- 
1.6.4.2