[U-Boot] configure ppc440spe as pci adapter

[Stefan Roese]

On Thursday 10 September 2009 21:01:57 dbrazeau wrote:
> I'm trying to get my ppc440spe (Katmai) board to initialize in PCI adapter
> mode.  I was hoping that someone could give me some pointers on what
>  changes I need in the katmai config file, i.e. do I need to define
> CONFIG_SYS_PCI_MASTER_INIT.  Also I noticed that some ppc4xx have
> PCI_HOST_ADAPTER defined, but this is not defined in the Katmai config
>  file. Should I define it and define CONFIG_PCI_HOST to it?  Any comments
>  are greatly appreciated.  Thanks.

I don't know of any 440SPe based board used in PCI adapter mode. But you could 
probably check the esd PMC440 board. This is a PPC440EPx based PMC module 
which can be configured/built either as PCI host or as PCI adapter.

Cheers,
Stefan

--
DENX Software Engineering GmbH,      MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich,  Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-0 Fax: (+49)-8142-66989-80 Email: office at denx.de