[U-Boot] [PATCH-ARM 4/4] Clean-up of s3c24x0 nand driver

[Wolfgang Denk]

Dear Scott Wood,

In message <20090911222349.GA26604 at b07421-ec1.am.freescale.net> you wrote:
> On Mon, Sep 07, 2009 at 12:15:22AM +0100, kevin.morfitt at fearnside-systems.co.uk wrote:
> > This patch re-formats the arm920t s3c24x0 nand driver in preparation for changes
> > to add support for the Embest SBC2440-II Board.
> > 
> > The changes are as follows:
> > - re-indent the code using Lindent
> > - make sure register layouts are defined using a C struct
> > - replace the upper-case typedef'ed C struct names with lower case
> > non-typedef'ed ones
> > - make sure registers are accessed using the proper accessor functions
> > - run checkpatch.pl and fix any error reports
> > 
> > It assumes the following patch has been applied first:
> > - [U-Boot][PATCH-ARM] CONFIG_SYS_HZ fix for ARM902T S3C24X0 Boards, 05/09/2009
> >  - patches 1/4, 2/4 and 3/4 of this series
> 
> Acked-by: Scott Wood <scottwood at freescale.com>

What does that ACK mean? Who is supposed to apply this patch - the ARM
custodian?

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
The moral of the story is: "Don't stop to  tighten  your  shoe  laces
during the Olympics 100m finals".
                             - Kevin Jones in <DEJo68.K1t at bri.hp.com>