[U-Boot] [PATCHv5 2/2] mucmc52, uc101: delete ata at 3a00 node, if no CF card is detected

[Wolfgang Denk]

Dear Heiko Schocher,

In message <4AAF1FE4.9050704 at denx.de> you wrote:
> U-Boot can detect if an IDE device is present or not.
> If not, and this new config option is activated, U-Boot
> removes the ATA node from the DTS before booting Linux,
> so the Linux IDE driver does not probe the device and
> crash. This is needed for buggy hardware (uc101) where
> no pull down resistor is connected to the signal IDE5V_DD7.
> 
> Signed-off-by: Heiko Schocher <hs at denx.de>

Seems this patch depends on other patches, that add support for the
manroland boards, which have not been accepted yet. I think I'm
waiting for a resubmit from you?

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
ATTENTION: Despite Any Other Listing of Product Contents Found  Here-
on, the Consumer is Advised That, in Actuality, This Product Consists
Of 99.9999999999% Empty Space.