[U-Boot] [PATCH 0/2 v5][U-BOOT] Zoom3: Add support for OMAP3630 Zoom3 board.

[Martinez, Aldo]

Dear Wolfgang,
> -----Original Message-----
> From: Martinez, Aldo
> Sent: Friday, July 16, 2010 1:30 AM
> To: u-boot at lists.denx.de
> Cc: Paulraj, Sandeep; wd at denx.de; Martinez, Aldo
> Subject: [PATCH 0/2 v5][U-BOOT] Zoom3: Add support for OMAP3630 Zoom3
> board.
> 
> From: Aldo Brett Cedillo Martinez <aldo.cedillo at ti.com>
> 
> This patch set gives basic functionality to Omap3630 Zoom3 board. And
> unifies serial_devices for zoom2 and zoom3 since both use the same
> struct.
> 
> Thanks Wolfgang for your comments, the modifications done were:
> - Added entry to MAINTAINERS in proper order.
> - Macro for UART1_RX pin.
> - Left include for status led unconditional.
> - Unindented preprocessor statements.
> - Made CONFIG_SYS_HZ a constant with value 1000.
> - Zoom2 and Zoom3 devices now use the same serial device.
> 
> Aldo Brett Cedillo Martinez (2):
>   [U-BOOT] Zoom3: Add support for OMAP3630 Zoom3 board.
>   [U-BOOT] Unify serial_device for zoom2 and zoom3.

I wonder what is the status of this patch? 
Sandeep commented me it was dependent on another patch, maybe a serial driver patch. The second patch of this series affects include/serial.h, should I make any modifications to patch so it can apply?

Thanks and best regards,
Aldo