[U-Boot] [PATCH 0/2 v5][U-BOOT] Zoom3: Add support for OMAP3630 Zoom3 board.

[Martinez, Aldo]

Hi Jeff,

> -----Original Message-----
> From: Jeff Carr [mailto:basilarchia at gmail.com]
> Sent: Tuesday, August 17, 2010 6:53 PM
> To: Martinez, Aldo
> Cc: u-boot at lists.denx.de
> Subject: Re: [U-Boot] [PATCH 0/2 v5][U-BOOT] Zoom3: Add support for
> OMAP3630 Zoom3 board.
> 
> On Tue, Aug 17, 2010 at 14:43, Jeff Carr <basilarchia at gmail.com> wrote:
> > On Tue, Aug 17, 2010 at 08:34, Martinez, Aldo <aldo.cedillo at ti.com>
> wrote:
> >
> >> I wonder what is the status of this patch?
> 
> I tried this patch today and DRAM seems to not work after u-boot
> loads. Strange. I did:
> 
> git clone git://git.denx.de/u-boot.git
> git pull git://git.denx.de/u-boot-ti.git master
> patch < your_patch_from_this_thread.diff
> export CROSS_COMPILE=arm-none-linux-gnueabi-
> make omap3_zoom3_config
> make
> 
> Then the output looks like:
> 
> U-Boot 2010.06-00691-g30b170e-dirty (Aug 17 2010 - 15:58:42)
> 
> OMAP3530-GP ES2.0, CPU-OPP2 L3-165MHz
> OMAP3 Zoom3 + LPDDR/NAND
> DRAM:  640 MiB
> NAND:  512 MiB
> In:    serial
> Out:   serial
> Err:   serial
> Board revision Production
> Die ID #782400011ff00000015a5e591101d014
> Hit any key to stop autoboot:  0
> OMAP3 Zoom3 #bdinfo
> arch_number = 0x000009A0
> env_t       = 0x00000000
> boot_params = 0x80000100
> DRAM bank   = 0x00000000
> -> start    = 0x80000000
> -> size     = 0x20000000
> DRAM bank   = 0x00000001
> -> start    = 0xA0000000
> -> size     = 0x08000000
> baudrate    = 115200 bps
> OMAP3 Zoom3 #md 0x80001000
> 80001000:
I'll take a look at this, thanks for noting it. 

Best regards,
Aldo Brett