[U-Boot] Non-experimental U-Boot compilation

[sandeep suresh]

Dear all,
     I am using the AT91SAM9G20EK kit and want to port Linux on this. I am using 
the AT91SAM9260ek configuration as it seems the closest. The problem is after 
building the U-boot with the sources for this board, generating the .bin, 
loading and a power on reset (POR), there isn't a command prompt exposed 
(u-boot>). After POR, 1 1 2 1 1 2 continuosly prints on the hyperterminal. I 
read from AT91.com that this is the expected behavior for the demo version. What 
is rge procedure to get the prompt ? Are there any separate configuration 
settings?
Please help as I am stuck.
Thanks & regards
Sandeep.