[U-Boot] [PATCH] MTD: Add support for S25FL032P spi nor-flash

[David Jander]

On Monday 23 August 2010 06:31:26 pm Mike Frysinger wrote:
> On Monday, August 23, 2010 09:12:16 David Jander wrote:
> > +	{
> > +		.idcode1 = SPSN_ID_S25FL032A,
> > +		.idcode2 = SPSN_EXT_ID_S25FL032P,
> > +		.idmask2 = 0xff00,
> 
> what does the idcode2 look like such that you need a mask ?
> -mike

According to the datasheet the RDID command (0x9f) returns the following 
bytes:

byte 0: Manufacturer ID = 0x01
byte 1,2: Device ID = 0x02, 0x15 (same as S25FL032A)
byte 3: Extended ID = 0x4d
byte 4,5,6: Spansion reserved (do not use).

byte 4 is read as 0x00 on my part, but due to the above explaination, I cannot 
say for sure it is always the same, so I had to implement a mask to check for 
it.

Best regards,

-- 
David Jander
Protonic Holland.
tel.: +31 (0) 229 212928
fax.: +31 (0) 229 210930
Factorij 36 / 1689 AL Zwaag