[U-Boot] [PATCH 1/1] MX51EVK: UART does not print out the early information

[Stefano Babic]

On 12/23/2010 12:13 PM, Jason Liu wrote:
> The early bootup information is not print out due to
> the UART pin iomux not set up correctly before board_init
> 
> Add the board_early_init_f function and enable the
> CONFIG_BOARD_EARLY_INIT_F. Move the UART pin setting
> from board_init to board_early_init_f function.
> 
> This patch also move the FEC pin iomux setup to the
> board_early_init_f.
> 
> Signed-off-by: Jason Liu <r64343 at freescale.com>
> ---

Applied to u-boot-imx, thanks.

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================