[U-Boot] [PATCH 0/9] Add support for i.MX25 SOC and TX25 board

[Wolfgang Denk]

Dear John Rigby,

In message <1263357841-5100-1-git-send-email-jcrigby at gmail.com> you wrote:
> The i.MX25 has the same ARM core and shares some ip blocks
> with i.MX27 but also borrows from i.MX31.
> 
> The TX25 is an i.MX25 based board.  It has only NAND flash
> so this port includes nand_spl and mtd/nand changes for
> the nand controller in the i.MX25.
> 
> Booting from nand also required adding nand_spl boot support 
> for arm926ejs.
> 
> Support is also included for serial and ethernet.
> 
> This port was made possible by a donation of hardware by
> DENX Software Engineering.
> 
> John Rigby (8):
>   mxc_serial replace platform specific clock
>   arm926ejs: add nand_spl boot support
>   Add v1.1 support to nand_spl fsl nfc driver
>   Nand mxc_nand add v1.1 controller support
>   fec_mxc: cleanup and factor out imx27 dependencies
>   Add support for Freescale MX25 SOC
>   fec_mxc: add imx25 support
>   Add support for KARO TX25 board

Tested building (both in- and out-of-tree) plus runtime on TX25.


Tested-by: Wolfgang Denk <wd at denx.de>

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
A good aphorism is too hard for the tooth of time, and  is  not  worn
away  by  all  the  centuries,  although  it serves as food for every
epoch.                                  - Friedrich Wilhelm Nietzsche
                          _Miscellaneous Maxims and Opinions_ no. 168