[U-Boot] Transfer file using loadb

[Chetan Nanda]

Tried with loady command in u-boot and ymodem option from minicom.
With this combination I am able to transfer and run uImage.

~cnanda

On Sat, Jan 30, 2010 at 10:02 PM, Wolfgang Denk <wd at denx.de> wrote:

> Dear Chetan Nanda,
>
> In message <7f245da81001300735x6d0727f8s2f530d6a3540e2b5 at mail.gmail.com>
> you wrote:
> >
> > Every time after this transfer get started but then aborted automatically
> > with following error message:
> ...
> > HINTS... If the preceding error message does not explain the failure:
> >  . Try changing the remote Kermit's FLOW-CONTROL setting.
> >  . Increase the retry limit (see HELP SET RETRY).
> >  . Try it again with SET STREAMING OFF.
> >  . Try it again with SET PARITY SPACE.
> >  . As a last resort, give a ROBUST command and try again.
>
> So - have you tried any of these hints?
>
> The kermit developer tried the best they could do to help you by
> providing valuable hints for configuration settings that might help to
> solve your problem - and did you follow their advice?
>
> Also, did you RTFM? The manual contains a section on how to configure
> kermit for reliable work:
>
> http://www.denx.de/wiki/view/DULG/SystemSetup#Section_4.3.
>
> Did you really adapt your ~/.kermrc as recommended?
>
> Best regards,
>
> Wolfgang Denk
>
> --
> DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
> HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
> Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
> "Bureaucracy is the enemy of innovation."
>       - Mark Shepherd, former President and CEO of Texas Instruments
>