[U-Boot] [PATCH] [v3] powerpc: add support for the Freescale P1022DS reference board

Wolfgang Denk wd at denx.de
Wed Jul 14 21:42:15 CEST 2010


Dear Timur Tabi,

In message <1276547304-10105-1-git-send-email-timur at freescale.com> you wrote:
> Add basic suport for the Freescale P1022DS reference board.
> 
> Specifics:
> 
> 1) 36-bit only
> 2) Booting from NOR flash only
> 3) Environment stored in NOR flash only
> 4) No SPI support
...
> +int checkboard(void)
> +{
> +	u8 sw;
> +
> +	puts("Board: P1022DS ");
> +
> +	printf("Sys ID: 0x%02x, Sys Ver: 0x%02x, FPGA Ver: 0x%02x, ",
> +		in_8(&pixis->id), in_8(&pixis->arch), in_8(&pixis->scver));
> +
> +	sw = in_8(&PIXIS_SW(PIXIS_LBMAP_SWITCH));
> +
> +	switch ((sw & PIXIS_LBMAP_MASK) >> 6) {
> +		case 0:
> +			printf ("vBank: %u\n", ((sw & 0x30) >> 4));
> +			break;
> +		case 1:
> +			printf ("NAND\n");
> +			break;
> +		case 2:
> +		case 3:
> +			puts ("Promjet\n");
> +			break;
> +	}

Incorrect indentation.


Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
On a clear disk you can seek forever.


More information about the U-Boot mailing list